Built-in user interfaces 

Built-in user interfaces (with display)

For our VMC, the Input / Output module is a device to transform RF signals to a wired output signal or transform digital inputs signals to RF. The output of the platform is an analogue 0-10 VDC signal, normally used to control a ventilation box. You can bind e.g. a wireless sensor to this product which converts the wireless sensor information into a 0-10 VDC wired signal. On the inputs you can connect e.g. an error relay out and a filter dirty relay output. Then this signal will be transformed in a wireless RF signal.

​

Our VMN products can also be used as built-in devices. 

​

The VMI-02VCW01 is a user control and CO2 sensor for ventilation systems in homes and buildings. Next to that we have the VMI-02WSJ44 which is a display that is a user and installation interface to monitor and set the connected heat recovery unit. This unit enables you to control the indoor climate by varying the ventilator speed. The device uses wireless communication (RF) to communicate with the HRU. Capacitive touch buttons on the device allow for changes in settings of the recovery unit. The liquid crystal display (LCD) of the device shows the actual working state the unit is in. When a malfunction of, or a problem with the heat recovery unit occurs, the LCD shows the fault of the system.

​

The servicemenu can be used for HRU settings during and after installation. This display is supported by all our VMD products.